KURT DIY-R8 REPLACEMENT DRAWBARKURT DIY-R8 REPLACEMENT DRAWBAR DIY-R8, DO-IT-YOURSELF REPLACEMENT BAR ONLY This Kit consists of a drawbar head blank, with the spline pre-machined and hardened, and a drawbar rod blank that includes a grooved pin, to pin the head and rod together AFTER they are machined by YOU! There are directions included with each kit and after you get your measurements, you do the following; 1. Press the drawbar rod into the drawbar head until the end of the head pilot diameter is even with the turned portion of the drawbar rod. 2. Measure up 7/16" from the end of the drawbar head that the rod was pressed into. Center drill, drill and ream a 3/16" diameter cross-hole thru the assembly in the 7/8" diameter portion of the head. 3. Deburr the hole on both sides. 4. Press the supplied grooved pin into this hole, small end first, until the head of the in is flush to slightly below the surface of the rod. The Drawbar Assembly is finished! Any problems or questions, contact Kurt Manufacturing Toll Free at 877-226-7823 or at www.kurtworkholding.com, GOOD LUCK!
100% Satisfaction Guarantee: At Mansion Tools, we want to be sure that the item you choose is the right one for you. Within 30 days of delivery of your order, you may return any merchandise purchased from Mansion Tools in its original condition with your email order confirmation or packing slip. Restocking fees may apply. On items over $275 shipping within the US, we will even arrange free pick up or pay for returns shipping.